Add More
Perma Grit - Rotary Ball - Fine 10mm (D) 3mm (S)
Part No: T-PGRF8F
Small Rotary Rotary Ball Fine Grit, shaping, keying and lightening. Shaft / arbor - 3.1 mm (1/8") Overall length - 34mm Gritted length - 10.5mm Widest point - 10mm (all measurements are approx...
£12.99
This item is available from our supplier.
The delivery time will increase by 2-5 days.
The delivery time will increase by 2-5 days.
Small Rotary
Rotary Ball Fine Grit, shaping, keying and lightening.
Shaft / arbor - 3.1 mm (1/8")
Overall length - 34mm
Gritted length - 10.5mm
Widest point - 10mm
(all measurements are approximate)
Perma Grit Rotaries have an integral arbor, enabling them to be used in reversible drive tools. They allow you to cut a wide range of materials quickly and cleanly leaving an excellent finish. All rotaries are ideal for routing, shaping and removing materials without tearing or clogging.
Use on all Woods, Glass Fibre, Carbon Fibre, PCB, Kevlar, Plexiglas, Lexan, Perspex, Acrylics, Plastics, Polystyrene, Ceramics etc.
Excellent on Perspex, Plexiglass, Lexan and if used below 10,000 RPM and they will not melt, crack or chip them. Not recommended for use on metal.
Note Rotaries should be fully inserted in to the chuck and tightened before using. Maximum RPM 20,000 Low - Medium.
SAFETY:- Always wear protective goggles when using Rotary Tools.
IMPORTANT:- Carbon Fibre should not be cut using an electric drill, because of the possibility of electrocution.
Rotary Ball Fine Grit, shaping, keying and lightening.
Perma Grit Rotaries have an integral arbor, enabling them to be used in reversible drive tools. They allow you to cut a wide range of materials quickly and cleanly leaving an excellent finish. All rotaries are ideal for routing, shaping and removing materials without tearing or clogging.
Use on all Woods, Glass Fibre, Carbon Fibre, PCB, Kevlar, Plexiglas, Lexan, Perspex, Acrylics, Plastics, Polystyrene, Ceramics etc.
Excellent on Perspex, Plexiglass, Lexan and if used below 10,000 RPM and they will not melt, crack or chip them. Not recommended for use on metal.
Note Rotaries should be fully inserted in to the chuck and tightened before using. Maximum RPM 20,000 Low - Medium.
SAFETY:- Always wear protective goggles when using Rotary Tools.
IMPORTANT:- Carbon Fibre should not be cut using an electric drill, because of the possibility of electrocution.